Top-Rated Commercial Plumbers in Akron, OH

# Plumbing Service - Water Leak Responded to a callback for an unresolved bathroom leak in an 80-year-old residence. Upon arrival, accessed the attic crawl space above the affected bathroom to investigate the source of the persistent leak. Inspection revealed compromised plumbing connections in the confined space where water supply lines interface with aged structural components. Navigated through the tight attic access point to examine PVC piping and brass fittings located near HVAC ductwork and fiberglass insulation. Identified the leak source at a threaded pipe connection that had failed due to deterioration of the fitting and movement in the aging structure. The original repair from the previous visit had not addressed the root cause of the leak, which was related to settling and structural flex in the 80-year-old framing. Performed necessary repairs to the compromised connection, ensuring proper sealing and support to prevent future movement-related failures. Documented the con

Responded to water leak complaint in older residential property. Upon inspection, identified heavily corroded valve assembly on water heater with significant rust accumulation at outlet port, indicating active moisture exposure and probable leak source. The brass/bronze valve body exhibited extensive oxidation and patina consistent with age-related deterioration. Inspected associated braided stainless steel flex lines and PVC connections for additional compromise. Documented condition of corroded components and plumbing configuration in utility space. Assessed surrounding areas including basement/crawlspace plumbing for related leak issues or water damage.

Responded to a backyard drainage issue at a 70-year-old residential property. Inspected the exterior ground water drainage system, including PVC discharge piping along the building foundation and surrounding gravel drainage border. Assessed the hexagonal paver and concrete surface areas for proper water flow and documented the existing plumbing configuration with vertical discharge pipe and elbow fitting connection.

Responded to drainage issue on opposite side of facility as follow-up to previous service call. Performed inspection of exterior drain system and traced problem to main line connection at street level. Documented site conditions including street access point and sidewalk area where municipal connection requires attention. Recommended coordination with municipality for street-level drain line repair to resolve recurring drainage concerns.

Installed approximately 50 feet of 1.25-inch gas piping inside the residence, routing the line through the basement crawlspace between floor joists to supply gas to the designated appliance location. Connected the new gas line to the existing exterior meter assembly, performed pressure testing to verify system integrity, and ensured all connections meet code requirements for safe operation.

Responded to commercial water leak and low water pressure complaint. Upon inspection, identified corroded fittings on copper piping at water heater location. Examined water softener system and associated plumbing connections. Found turquoise-colored pipe fitting showing significant corrosion and mineral deposit buildup, contributing to reduced water flow. Inspected shut-off valves, braided stainless steel supply lines, and drain pan beneath water heater assembly. Confirmed presence of deteriorated fittings requiring replacement to restore proper water pressure and prevent potential leaks. Documented plumbing infrastructure condition including blue and red-handled valves, flexible metal hoses, and mounting configuration within utility enclosure.

Installed complete dual shower system in existing bathroom, including overhead rain-style showerhead and adjustable slide bar with handheld showerhead assembly. Mounted chrome fixtures to white acrylic shower surround, connected flexible metal hose to water supply, and installed temperature and flow control valves to provide full functionality for the new handheld shower configuration.

Responded to gas leak service call and performed comprehensive pressure testing of gas lines. Upon arrival, conducted thorough inspection of the affected area and utilized specialized testing equipment to identify and verify the leak location. Successfully completed pressure test protocol to ensure system integrity and safety compliance. Documentation captured showing testing apparatus in place with yellow corrugated test hose connected to gas line system for pressure monitoring and leak detection verification.

Replaced two existing grinder pumps with new Zoeller grinder pump units, including all necessary materials and labor. The installation was completed in the designated utility space, with both pumps properly mounted, wired, and tested for functionality. All electrical connections and discharge piping were secured to manufacturer specifications.

Responded to dual kitchen sink drainage issue in 1942-built home where previous plunging and chemical drain cleaner attempts had failed. Inspected under-sink plumbing configuration, identifying standard white PVC P-trap assembly beneath sink basin. Assessed drainage system for blockages, cleared obstruction in drain line, and restored proper flow to both kitchen sinks. Verified all connections secure and tested drainage performance to ensure complete resolution of backup issue.

Replaced damaged waterlines with new copper piping and flexible supply lines. Installed brass fittings to connect vertical copper pipes to color-coded hot and cold water supply lines, secured the plumbing assembly to wooden backing board, and applied spray foam insulation around all pipe penetrations to seal gaps and prevent air infiltration. All connections were tested for proper flow and verified leak-free operation upon completion.

Responded to ground water drain backup issue in garage that occurs during rainfall. Performed initial site assessment and located exterior drainage components in front yard area. Utilized detection equipment to trace drain line path and identify potential blockage points or system failures causing the recurring backup condition.

# Downspout and Ground Water Drainage System Replacement Replaced deteriorated downspouts and installed new ground water drainage system on the front exterior of residential brick units. Work included excavation along the foundation, installation of white PVC downspout extensions mounted to brick exterior, and underground drainage piping utilizing turquoise and white PVC components with proper elbows and fittings to direct water away from the building foundation. Backfilled excavated areas and restored ground surface upon completion.

Responded to service call for main drain cleanout as required by inspection and laundry room drain issues. Accessed main cleanout assembly and removed blockage from primary drain line using appropriate drain cleaning equipment. Cleared obstruction and restored proper flow through the drainage system. Inspected laundry room drain connections including P-trap assembly and verified all fixtures were draining correctly. Tested water flow through both the main line and laundry room drainage to confirm complete clearance and proper operation of all plumbing components.

Responded to service call for frozen and damaged plumbing pipes beneath kitchen sink. Replaced compromised PVC drain assembly including P-trap configuration with new white PVC piping and fittings. Verified proper drainage flow and checked all connections for leaks before completing installation.

Responded to alarm condition on sewer pump system. Upon arrival, inspected the control panel and circuit board assembly manufactured by Relay Fabrication Inc., checking all electrical connections, relay operations, and alarm circuit functionality. Tested system components including power supply, transformer, and control relays to identify the source of the alarm condition. Verified proper wiring connections at terminal points and ensured all safety circuits were functioning correctly. System was evaluated and cleared for operation, with alarm condition resolved prior to business opening.

Responded to service call for sewer line repair connected to grinder pump system. Upon inspection, identified damaged sewer line requiring repair work in exterior hillside area beneath elevated deck structure. Assessed drainage and plumbing components, documented existing conditions with photos showing exposed PVC piping and gravel terrain, and confirmed repair requirements for proper connection to grinder pump system.

Installed 30 feet of 1-inch gas piping from an interior 1.5-inch supply tap to service HVAC equipment, including furnace and outdoor air conditioning condenser unit. Routed gas line through basement utility area and exterior wall to green gas meter mounted on building exterior, ensuring proper connection to all appliances and compliance with permit requirements for Summit County.

Responded to emergency water service call for suspected underground pipe failure with water supply shut off to property. Upon arrival, conducted thorough inspection of mechanical room and exterior utility areas to locate source of leak. Documented extensive water damage evidence in basement mechanical room, including significant mineral deposits and sediment accumulation on concrete floor near HVAC equipment, indicating prolonged water intrusion. Traced water supply lines and identified blue utility markings on exterior concrete near foundation, suggesting previous excavation work or known utility line location. Assessed damage patterns and determined underground pipe breach as likely cause based on water shutoff necessity and visible evidence. Captured photographic documentation of affected areas for insurance and repair planning purposes. Recommended excavation and pipe replacement services to address underground leak source.

Responded to emergency service call for non-operational grinder pump system. Upon arrival, performed comprehensive inspection of pump station and associated components. Found grinder pump mechanism had failed due to worn impeller assembly and compromised float switch system. Removed defective pump unit from basin, inspected discharge piping and electrical connections for additional issues. Replaced failed pump assembly with new grinder pump unit, installed new float switch mechanisms to ensure proper automatic operation, and verified all electrical connections were secure and code-compliant. Tested system operation through multiple cycles to confirm proper pump activation, grinding function, and automatic shutoff. Cleared debris from basin, secured all components, and restored full functionality to grinder pump station.