Top-Rated Commercial Plumbers in Akron, OH

Performed main drain jetting service at a century-old residential property to clear blockages in the primary drainage system. Accessed the main drain line through the basement level, deployed high-pressure water jetting equipment to remove accumulated debris and restore proper flow. Successfully cleared the line and verified drainage functionality upon completion.

Responded to call for basement flooding due to sump pump failure with suspected main drain clog. Upon arrival, performed diagnostic assessment of drainage system and conducted requested camera inspection to identify blockage location and assess line condition. Exterior inspection completed to evaluate discharge points and verify proper drainage flow from foundation perimeter systems.

Completed septic tank pumping service at residential property. Pumped and removed 160 gallons of septage from system. Performed comprehensive inspection of tank components, risers, filters, and distribution system during service. Tanks scheduled to be crushed and filled on site per property requirements.

Responded to commercial grease trap service request and performed initial assessment of the system. Upon inspection, documented extensive corrosion and deterioration throughout the drainage area, including heavy rust accumulation, mineral deposits, and debris buildup indicating prolonged moisture exposure and deferred maintenance requiring attention prior to jetting operations.

Returned to complete plumbing installation that was previously postponed while concrete work was finished around pipe penetrations. Installed PVC cap fitting on floor-mounted drain line, securing the threaded connection to complete the rough-in work in the basement utility area.

Completed gas line enlargement from main supply to furnace and water heater to accommodate increased demand. Ran additional gas lines for future dog wash station installation during the line drop process. Installed new 50-gallon gas-fired water heater with proper venting and connections. All ductwork, gas piping, and HVAC components were properly secured and integrated into the existing mechanical system. Installation includes metallic ductwork with appropriate transitions, flexible ducting connections, PVC condensate drain lines, and filtration components mounted according to code specifications.

Replaced existing 3-inch backflow prevention assembly that exhibited significant corrosion and deterioration throughout the valve body, flanges, and connection points. The old assembly showed extensive oxidation and compromised integrity that required complete removal and installation of new backflow device with proper shutoff valves, ensuring compliance with plumbing codes and maintaining system protection against water contamination.

Responded to multiple plumbing leaks including toilet leak penetrating ceiling, kitchen sink leak, and bathroom sink leak. Inspected toilet seal and wax ring for source of water intrusion causing ceiling damage. Examined kitchen sink drain assembly and P-trap, noting discoloration and residue buildup on PVC components indicating previous leak activity. Assessed drain connections, compression fittings, and trap assembly for proper sealing. Inspected bathroom sink plumbing fixtures and drain components. Addressed all leak sources to prevent further water damage and restore proper drainage function throughout affected areas.

Responded to drainage issue at front right downspout where water was pooling on brick paver surface near building foundation. Successfully snaked the underground drain line to clear blockage and restore proper water flow from the downspout discharge point. Documented existing conditions showing standing water on pavers and confirmed clearance of obstruction, with drainage system now functioning as designed.

Pumped and serviced a 1,000-gallon commercial grease trap system using dual hose configuration from asphalt parking lot access point. Completed all required FOG (Fats, Oils, and Grease) regulatory documentation and disposal procedures in accordance with environmental health standards.

Responded to drainage issue at approximately 40-year-old residence on second scheduled visit. Upon arrival, assessed exterior drainage system and identified water flow from curb drainage pipe opening onto street pavement. Inspected residential plumbing drainage infrastructure and cleared obstruction causing backup in main drain line. Verified proper water flow through system and confirmed drainage issue resolved. Property exterior showed normal water discharge through curb outlet following service completion.

Responded to basement drain backup with potential collapse in front yard area. Excavated trench through lawn to access underground drainage system, exposing compromised ground water drain line. Completed necessary repairs to restore proper drainage function and prevent further structural concerns in the affected yard area.

Conducted on-site assessment for kitchen faucet replacement. Evaluated existing chrome two-handle faucet installation on stainless steel double-basin sink, noting significant wear, mineral deposits, and staining on fixtures and basin surfaces. Inspected underlying plumbing connections in basement area, including supply lines, shut-off valves, and drainage components to determine scope of replacement work. Provided comprehensive estimate for complete faucet replacement including removal of existing fixture, installation of new faucet assembly, and verification of all supply line connections.

# Plumbing Service Completed Responded to service call for suspected gas leak originating from HVAC system in residential property constructed in 1964. Upon arrival, conducted thorough inspection of mechanical systems in basement/crawl space area and accessed plumbing behind interior wall. Inspection revealed aging brass and copper piping with threaded connections showing signs of corrosion and surface discoloration consistent with original 1964 installation. Examined valve assembly with brass fittings and multiple pipe segments with threaded couplings supported by foam pipe insulation. Created wall access point to expose concealed plumbing system for comprehensive evaluation of pipe conditions and connections. Assessed horizontal pipe runs with valves and connectors for potential leak sources. Evaluated condition of all visible joints, fittings, and connections throughout the plumbing system. Inspected interface between plumbing components and HVAC ductwork to identify potential g

Completed cartridge replacement and shower diverter installation on a Delta single-handle tub/shower faucet in a 75-year-old home. Accessed the wall cavity to expose existing plumbing infrastructure, removed the failed cartridge from the valve body, and installed a new replacement cartridge to restore proper temperature control and water flow. Installed a new shower diverter mechanism to allow switching between tub spout and showerhead functions. Reassembled the trim components, tested all functions for proper operation, and verified no leaks were present at the valve body or connections.

Responded to service call for toilet flange repairs in multi-level residential property. Upon arrival, found subfloor had been removed to allow access to plumbing fixtures. Successfully installed new add-a-flange assembly for first floor bathroom toilet to restore proper mounting height and seal integrity. Inspected second floor bathroom flanges and identified both require raising to meet proper installation specifications. Work on second floor flanges scheduled for return visit once subfloor replacement is completed. All accessible plumbing connections secured and tested for initial installation phase.

Installed approximately 60 feet of Schedule 35 PVC drainage pipe from the rear left corner of the residence to the street, terminating with a pop-up emitter. Excavated trench through front lawn to accommodate new drainage line. Modified existing sump pump discharge by cutting the 1-1/2" line after the existing 90-degree elbow, installed additional 90-degree fitting, and redirected discharge into a dedicated 4" riser for improved drainage performance. Backfilled trench upon completion of installation.

Responded to service call for non-operational commercial garbage disposal unit. Upon inspection, identified Salvajor Model 300 disposal system installed under commercial sink with visible signs of wear and operational failure. Assessed unit condition, documented equipment specifications and installation configuration, and photographed disposal assembly including mounting, drainage connections, and electrical components for service records and future reference.

Installed 10 feet of gas piping to an exterior tap location on the outside of the building. Ran new gas line along the exterior wall near the existing utility meter and electrical equipment, ensuring proper support and code-compliant installation for safe gas delivery to the outdoor appliance connection point.

Responded to a service call regarding a former parking lot drainage system that had been filled in and blocked. Conducted on-site inspection of the area where the drain previously existed. Assessed the current condition of the filled drainage point and surrounding concrete surfaces to determine requirements for restoration. Evaluation completed to provide estimate for excavation, installation of new drainage piping, and placement of appropriate grate cover to restore proper stormwater management functionality to the commercial property.